With more than 25 years industry experience assessing EFI systems on a wide variety of vehicles, we offer EFI diagnosis based on our experience, not just scan tool data. We can assist in assessment, diagnosis and recommended repairs to correct vehicle problems. This can include diagnosis on our chassis dyno, which can be required if the problem requires specific driving conditions to reproduce the symptom.
Modern Fuel Injection
There is a mass airflow sensor or manifold absolute pressure sensor at the intake, typically mounted either in the air tube feeding from the air filter box to the throttle body, or mounted directly to the throttle body itself. The mass airflow sensor does exactly what its name implies; it senses the mass of the air that flows past it, giving the computer an accurate idea of how much air is entering the engine.
The next component in line is the Throttle Body. The throttle body has a throttle position sensor mounted onto it, typically on the butterfly valve of the throttle body. The throttle position sensor (TPS) reports to the computer the position of the throttle butterfly valve, which the ECM uses to calculate the load upon the engine. The fuel system consists of a fuel pump (typically mounted in-tank), a fuel pressure regulator, fuel lines (composed of either high strength plastic, metal, or reinforced rubber), a fuel rail that the injectors connect to, and the fuel injector(s). There is a coolant temperature sensor that reports the engine temperature to the ECM, which the engine uses to calculate the proper fuel ratio required.
In sequential fuel injection systems there is a camshaft position sensor, which the ECM uses to determine which fuel injector to fire. The last component is the oxygen sensor. After the vehicle has warmed up, it uses the signal from the oxygen sensor to perform fine tuning of the fuel trim. The fuel injector acts as the fuel-dispensing nozzle. It injects liquid fuel directly into the engine’s air stream. In almost all cases this requires an external pump. The pump and injector are only two of several components in a complete fuel injection system.